Mechanic 10ML GY UVH900 Yellow UV Curable Solder Mask Paint For PCB Jumper Wire

Mechanic GY-UVH900 UV-curable solder mask paint in Yellow - a 10 ml syringe of single-component solder resist used by phone repair technicians to insulate and protect printed circuit board traces and jumper wires after micro-soldering.

Apply a thin layer over the area you want to protect, cure under a UV lamp (or strong direct sunlight) for a few minutes, and the paint sets into a tough yellow coating that mirrors the look of a factory solder mask.

Features:

• Insulates PCB Traces: Protects the board against shorting and arcing across closely-spaced pads after rework.
• Seals Jumper Wires: Locks down hand-routed jumper wires and bodge wires after micro-soldering so they cannot lift or short.
• Corrosion and Moisture Barrier: Cured coating helps shield exposed copper from moisture, flux residue and finger oils.
• UV Cure in Minutes: Sets under a UV lamp or strong direct sunlight - no thermal curing or oven needed.
• Yellow Solder Mask Finish: Yellow coating to match the section of board you are repairing or to colour-code your own jumpers.

How to use:

• Apply a thin bead of paint across the area to be protected.
• Cover with the transparent mask film to spread the paint evenly.
• Expose to UV light (or strong direct sunlight) for a few minutes until cured.
• Wash away any excess uncured paint with gasoline or an oil-based solvent.

Specifications:

• Brand: Mechanic
• Model: GY-UVH900
• Volume: 10 ml syringe
• Colour: Yellow
• Type: single-component UV-curable solder mask paint
• Cure method: UV light or strong direct sunlight
• Syringe length: approximately 10 cm

Compatibility: mobile phone logic boards and general PCB rework. Suitable for board-level repair benches that already have a UV cure lamp.

Package Contents:

• 1 x 10 ml Mechanic GY-UVH900 UV Curable Solder Mask Paint in Yellow