Adhesive For Apple Watch Screen Ultra / Ultra 2 / Ultra 3 49mm Pack of 2

This is a pack of 2 die-cut screen adhesive seals for the Apple Watch Ultra 49mm, Apple Watch Ultra 2 49mm and Apple Watch Ultra 3 49mm. Each seal sits between the display and the watch case and holds the screen firmly in place once it has been refitted.

When a watch screen is lifted for a battery or display job, the original adhesive tears and the screen will not sit flush or stay closed without a new seal. A pre-shaped seal means no cutting or trimming tape to size, and the display goes back down evenly all the way round. With two seals in the pack you have a spare if the first one is placed badly.

The seal follows the outline of the 49mm display opening so it lines up with the edge of the case. Peel the backing, place it on the clean case, remove the top liner, then press the screen down and hold it under gentle pressure for a few minutes.

Clean away every trace of the old adhesive with isopropyl alcohol before fitting and make sure the case is completely dry. A light clamp gives the best bond.

Made for the 49mm case size only. Other sizes use a different shape, so please check the case size on the back of your watch before ordering.

Specifications:

• Fits: Apple Watch Ultra 49mm, Apple Watch Ultra 2 49mm, Apple Watch Ultra 3 49mm
• Case size: 49mm
• Type: Screen adhesive seal, die cut
• Pieces: 2

Package Contents:

• 2 x Screen Adhesive For Apple Watch Ultra / Ultra 2 / Ultra 3 49mm