Lite Press Clamp Pressure Holding Fixture for Phone Repair iFixes iPH9

The iFixes iPH9 Lite Press Clamp is a simple pressure-holding fixture for phone repair. After you fit a new screen, back glass or frame with adhesive, lay the phone between the two padded plates and turn the knobs to hold it under steady, even pressure while the adhesive sets.

Holding parts by hand or with rubber bands gives uneven pressure and can leave gaps at the edges. This clamp spreads the load across the whole face of the phone, so the bond line stays flat and the part seats evenly in the frame. It frees your hands for the next job on the bench while the glue cures.

Two star knobs, one at each end, set the clamping gap. Each knob runs on a spring post, so the top plate lifts back up as soon as you loosen it, making it quick to load and release the phone. Adjusting each end on its own lets you balance the pressure along the length of the handset.

Both plates carry a cushioned contact pad on the inner face, so the glass and the frame are pressed through a soft layer rather than bare metal. The low-profile body sits on four small feet and takes up very little room on a repair bench.

Suitable for most modern smartphones that fit within the pad area. Check the size of your device against the pad before use, and set the pressure and holding time to suit the adhesive you are using.

Specifications:

• Brand: iFixes
• Model: iPH9
• Type: Pressure-holding fixture (press clamp)
• Plate size (each): 190 x 76 x 8 mm
• Pad size (each): 168 x 72 x 4 mm
• Adjustment: 2 star knobs on spring posts
• Colour: Black

Package Contents:

• 1 x iFixes iPH9 Lite Press Clamp