Mechanic DC 3010 Adjustable DC Regulated Bench Power Supply 30V 10A

The Mechanic DC 3010 is a benchtop adjustable DC regulated power supply for phone and tablet repair. Feeds a stable, current-limited 0-30V to a phone motherboard, letting the technician run the phone off the bench without its battery and safely trace power draw while diagnosing shorts, dead phones, boot loops or battery-charging faults.

Voltage and current are set with coarse and fine-tuning knobs and shown on a dual LCD readout - one channel for voltage, one for current draw in real time. Overcurrent limiting protects the phone under repair from a short-circuit fault on the bench, and short-circuit protection cuts the output if the probes touch.

Features:

• Output range: 0-30V DC, 0-10A - covers every mainstream smartphone, tablet and USB device rework voltage
• Dual LCD readout: live voltage and live current draw shown at the same time
• Coarse plus fine-tuning knobs on both voltage and current for precise set points
• Adjustable current limit - protects the target board from a short or over-draw during rework
• Short-circuit protection cuts the output if the probes make contact
• Front-panel banana-jack output terminals - pair with your existing boot cables
• Compact metal-cased bench form factor with rubber feet

Typical uses:

• Powering a phone without its battery for board-level diagnostics
• Reading current draw to isolate a short-circuit component
• Feeding a stable rework voltage during hot-air or preheater work
• Bench charging test rigs and USB-C / 8-Pin boot cables

Compatibility: Universal bench PSU - pairs with any Mechanic, QianLi, i2C or generic phone-repair boot cable that fits standard banana-jack outputs.

Package Contents:

• 1 x Mechanic DC 3010 adjustable DC regulated bench power supply
• 1 x mains cable (as supplied by the manufacturer)
• 1 x User instructions