2UUL DA03 Press Clamp For Phone Screen and Back Repair

The 2UUL DA03 Lite Press Clamp holds a phone's new screen or back glass firmly in place while you refit it. Lay the phone between the two padded jaws and turn the knobs until the part is held under steady, even pressure, then leave it clamped and your hands are free for the next job on the bench.

Pressing a screen or back glass by hand, with tape or with rubber bands gives uneven pressure, and the part can lift at the edges or sit proud of the frame. The DA03 spreads the pressure across the face of the phone, so the new glass stays flat and seats evenly in the frame, which helps give a clean, tight finish after a screen or back glass replacement.

The jaws carry protective pads, so the glass and the frame are pressed through a soft layer rather than bare metal. The pads pivot to follow the surface they rest on, which keeps the grip even on curved edges and camera bumps. The adjusting knobs let you set exactly how much pressure goes on, so you can go gently on thin glass and firmer on a frame.

The body is aluminium alloy, so it is light, rigid and resists corrosion and wear on a busy repair bench. It is the "Lite" version of the 2UUL press clamp, sized for phones; for tablets and larger devices, 2UUL makes the larger DA02 oversize clamp.

Use it for screen (LCD/OLED) refits, back glass replacement and frame reassembly on most smartphones that fit between the jaws. Check the size of your device against the jaw opening before use, and set the pressure and clamping time to suit the job.

Specifications:

• Brand: 2UUL
• Model: DA03 Lite Press Clamp
• Type: Press clamp (pressure-holding fixture)
• Material: Aluminium alloy body with protective pads
• Size: 199 x 80.5 x 52 mm
• Use: Holds screens, back glass and frames firmly in place during refitting
• Department: Unisex

Package Contents:

• 1 x 2UUL DA03 Lite Press Clamp